Y series sensors are mainly single-pressure sensors. Round sensors with a minimum diameter of 8mm to a diameter of 100mm are the main ones. The advantage is that the sensor with a relatively small diameter is suitable for installation in a small space. Suitable for small machines and fixtures. The disadvantage is that the diameter of the sensor is less than 15mm, and the fixed hole cannot be installed due to its small size.
For single force sensor installation, check whether there are threaded holes on the surfaces of the sensor. If there are holes, fix them with screws. Remember that the screws should not be too long and just fix them. If not, use the grooves to fix them. The groove is about two-thirds of the height of the sensor and will not fall off. Remember that the groove size is the positive tolerance of the sensor size.
Sensor housing (elastic element, sensitive beam) produces elastic deformation under the action of external force, so that the resistance strain gage (conversion element) pasted on its surface also deforms. After the resistance strain gage is deformed, its resistance value will change (increase). Larger or smaller), and then the resistance change is converted into an electrical signal (voltage or current) by the corresponding measuring circuit, thus completing the process of transforming the external force into an electrical signal.
1. Force source range of monitoring equipment machine.
2. Limit force source range not to be excessively high or low.
1. Button touch test
2. Plug and pull force test
3. Mobile screen test
4. Mobile phone HOME key test
5. Used in various assembly test equipment , for example: camera assembly equipment, screen assembly equipment, battery assembly equipment, speaker assembly equipment, welding equipment, circuit board assembly equipment, lock screw equipment, film equipment, hot and cold press, various test fixtures and etc.