X-ZL06 series Cantilever Tension Sensor

X-ZL06 series Cantilever Tension Sensor

It designed for installation equipment of single-side cantilever roller. It is integrated with cantilever shaft and roller components, so no special design required for the roller. Tension can be detected by inserting a spare roller into the cantilever tension detector. It can be used to measure and control the tension of materials during processing.

X-ZL06 series Cantilever Tension Sensor

Features

● Easy to install with various installation modes;

● Detection signal is not affected by the position of the coil;

● Built-in new mechanical 10 times anti-overload protection;

● Minor temperature drift,good Non-linearity and repeatability, small size, little space required for installation;

●Small size, little space required for installation;

● Standard M12*1 plug

 

Description

XJC-ZL06 series cantilever tension sensor is designed for installation equipment of singleside cantilever roller. It is integrated with cantilever shaft and roller components. This tension sensor can be installed on the inside or outside of the machine wall panel, and no special design required for the roller. Tension can be detected by inserting a spare roller into the cantilever tension detector. It can be used to measure and control the tension of materials during processing, such as paper, label, tape, battery electrode, high performance film and other narrow materials . The sensor’s detection signal will not be affected by the position of the coil on the roller.

 

Technical Parameter

Rated output1.0±10%mV/VNon-linearity0.2% F.S.
Repeatability0.1%F.S.Zero balance±2% F.S.
Operating temp range-20~80°CCompensated temp range-10~40°C
Temp effect on zero0.02%F.S/°CInsulation≥2000MΩ/100VDC
Recommended excitation voltage5~10VDCLimit load1000%F.S.
Cable sizeφ5x5mProtection classIP65

 

Dimensions

Force calculation

Installation

Two installation methods are as follows:

Note: Insert the sahft and roller components provided by customer into the cantilever tension sensor. Make sure the sensor’s housing and the machine wall panel will not be interfered by neither the shaft nor the roller components. The diameter of clearance holes on the machine wall panel should be at least 1.5mm larger than the shaft holes, and then fasten the four screws firmly to the shaft.

 

Scroll to Top
Contact Us
Get the latest catalogs and quotations.

Thank you for your message. We will reply to your message within 24 hours. Please look for emails with the suffix @xjcsensor.com.