Welcome To XJCSENSOR

XJC-Y01-13 Button load force sensor (0-1KN)

Short Description:

Features:

1. Small outer diameter

2. TEDS intelligent calibration function

3. Pressure type, high dynamic response

4. Run-in structure design, long service life

5. Material: Aluminum alloy (magnesium aluminum and aviation aluminum) and stainless steel 17-4PH and alloy steel: 42CRMO, 40CR, 40CRMOA, etc.

6. Running-in structure design, compression load, convenient and flexible installation;

7. Safe and explosion-proof load cell, which can be used in harsh environments and hazardous situations;High dynamic response frequency


Product Detail

Product Tags

XJC-Y01-13

Y series sensors are mainly single-pressure sensors. Round sensors with a minimum diameter of 8mm to a diameter of 100mm are the main ones.

The advantage is that the sensor with a relatively small diameter is suitable for installation in a small space. Suitable for small machines and fixtures.

The disadvantage is that the diameter of the sensor is less than 15mm, and the fixed hole cannot be installed due to its small size.

Y01-08

Principle

Sensor housing (elastic element, sensitive beam) produces elastic deformation under the action of external force, so that the resistance strain gage (conversion element) pasted on its surface also deforms. After the resistance strain gage is deformed, its resistance value will change (increase). Larger or smaller), and then the resistance change is converted into an electrical signal (voltage or current) by the corresponding measuring circuit, thus completing the process of transforming the external force into an electrical signal.

purpose:

1. Force source range of monitoring equipment machine.

2. Limit force source range not to be excessively high or low.

purpose:

1. The normal operating force range should be more than 10% of the full scale of the sensor, and the best effect is within 80%.

2. The range of normal operating force, the maximum output of the equipment (output of servo motors, cylinders, etc.) overshooting force should be taken into consideration in advance when selecting the sensor.

3. The accuracy of the sensor: Absolute accuracy, relative accuracy, use required accuracy, repeat accuracy, dynamic accuracy and static accuracy, measurement accuracy, control accuracy, system accuracy.

4. Installation method: screw fixing, plane fixing, external dimension requirements: length, width, height, outer diameter, etc.

5. Force method: Point force, surface force, through hole force, tension measurement, pressure measurement, torque, etc.


  • Previous:
  • Next:

  • Write your message here and send it to us